Matrix L4-1.8L (1ZZ-FE) (2008)
WIRING DIAGRAM
INSPECTION PROCEDURE
NOTE: Turn the ignition switch off before measuring the resistances of CAN bus main wires and CAN bus branch wires.
PROCEDURE
1. CHECK OPEN IN CAN BUS WIRE (STEERING ANGLE SENSOR BRANCH WIRE)
(a) Turn the ignition switch off.
(b) Disconnect the steering angle sensor connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:
NG -- REPAIR OR REPLACE STEERING ANGLE SENSOR BRANCH WIRE OR CONNECTOR
OK -- Continue to next step.
2. CHECK WIRE HARNESS (BAT, IG1, ESS)