Matrix L4-1.8L (1ZZ-FE) (2008)
NOTICE:
-
Check that there are no scratches or foreign objects around the connected part of the fuel tube connector and pipe before performing this
work.
-
After connecting the fuel tube, check that the fuel tube is securely connected by pulling the fuel tube connector.
(g) Install the fuel pipe clamp No. 1 (G).
(h) Install the 3 wire harness clamps (H).
(i) Connect the 4 fuel injector connectors (I).
3. CONNECT VENTILATION HOSE
(a) Connect the ventilation hose to the cylinder head cover.
NOTE: Make sure that the hose clamp is at the correct angle when installing.
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 5.4 Nm (55 kgf-cm, 48 in-lbf)
5. INSPECT FOR FUEL LEAK (See: Testing and Inspection)
6. INSTALL NO. 2 CYLINDER HEAD COVER
(a) Install the No. 2 cylinder head cover with the 2 nuts and 2 clips.
Torque: 7.0 Nm (70 kgf-cm, 62 in-lbf)