Matrix L4-1.8L (1ZZ-FE) (2008)
/Page-1048003.png)
(a) Install the starter drive lever set pin to the starter center bearing clutch as shown in the illustration.
2. INSTALL STARTER CENTER BEARING CLUTCH SUB-ASSEMBLY
(a) Install the starter center bearing clutch together with the starter drive lever set pin to the starter drive housing.
3. INSTALL PLANETARY GEAR
(a) Apply grease to the planetary gears and planetary shaft pins.
(b) Install the 3 planetary gears to the starter center bearing clutch.
4. INSTALL STARTER ARMATURE ASSEMBLY
(a) Apply grease to the washer and armature shaft.
(b) Install the starter armature and washer to the starter commutator end frame.
(c) Using snap ring pliers, install a new snap ring.
(d) Check the snap ring length.
(1) Using vernier calipers, measure the snap ring length.
Maximum length:
5.0 mm (0.197 in.)
If the length is greater than maximum, replace it with a new snap ring.
5. INSTALL STARTER COMMUTATOR END FRAME COVER