Matrix L4-1.8L (1ZZ-FE) (2008)
(b) Install the stabilizer bar front and 4 bolts to the front suspension crossmember sub-assembly.
Torque: 19 Nm (194 kgf-cm, 14 ft-lbf)
2. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY (See: Control Arm/Service and Repair/Installation)
3. INSTALL RACK & PINION POWER STEERING GEAR ASSEMBLY (See: Control Arm/Service and Repair/Installation)
4. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 LH (See: Control Arm/Service and Repair/Installation)
5. INSTALL FRONT SUSPENSION ARM SUB-ASSEMBLY LOWER NO. 1 RH
HINT: Install the RH side by the same procedures as the LH side.
6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH
(a) Install the stabilizer bar link with the 2 nuts.
Torque: 74 Nm (755 kgf-cm, 55 ft-lbf)
HINT: If the ball joint turns together with the nut, use a hexagon wrench (6 mm) to hold the stud.
7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT: Install the RH side by the same procedure as the LH side.
8. INSTALL FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
9. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: (See: Alignment/Service and Repair/Front Wheel Alignment)