Matrix L4-1.8L (1ZZ-FE) (2008)
09351-32150
Oil seal drive in depth:
1.5 to 2.5 mm (0.059 to 0.098 in.)
(b) Coat the lip of the oil seal with MP grease.
2. INSTALL TRANSAXLE CASE OIL SEAL (for LH Side)
(a) Using SST and a hammer, drive in a new oil seal.
SST: 09350-32014
09351-32111
09351-32130
Oil seal drive in depth:
4.8 to 5.8 mm (0.189 to 0.228 in.)
(b) Coat the lip of the oil seal with MP grease.
3. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
HINT: (See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Installation)
4. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
HINT: (See: Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service and Repair/Installation)
5. INSTALL ENGINE UNDER COVER LH
6. INSTALL ENGINE UNDER COVER RH
7. INSTALL FRONT WHEELS
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
8. ADD AUTOMATIC TRANSAXLE FLUID
Fluid type:
T-IV
Capacity:
3.0 liters (3.2 US qts, 2.6 lmp.qts)
9. INSPECT AUTOMATIC TRANSAXLE FLUID
HINT: (See: Service and Repair/Procedures)
10. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT: (See: Maintenance/Alignment/Service and Repair/Front Wheel Alignment)
11. CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)
HINT:
-
with VSC (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and
Diagnostic Overview/ABS (Antilock Brake System)/Test Mode Procedure)
-
without VSC (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and
Diagnostic Overview/Vehicle Stability Control System/Test Mode Procedure)