Matrix L4-1.8L (1ZZ-FE) (2008)
12. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Remove the 2 clip, 2 washer and disconnect the cable end of the control cable assembly from the transaxle.
(b) Remove the 2 clip and disconnect the control cable assembly from the bracket.
(c) Remove the 2 nuts and disconnect the control cable assembly.
(d) Disconnect the control cable assembly from the clamp.
(e) Remove the 2 bolts from the retainer.
(f) Pull out the control cable assembly from the floor.
(g) Remove the retainer from the grommet.