Matrix 2WD L4-1.8L (1ZZ-FE) (2003)
/Page-868006.png)
13. INSTALL STARTER ARMATURE ASSY
a. Apply grease to the washer plate and armature shaft.
b. Install the armature shaft to the starter commutator end frame assy.
c. Using snap ring pliers, install the plate washer and new snap ring.
d. Using vernier calipers, measure the snap ring
Maximum length: 5.0 mm (0.1969 in.)
If the length is greater than maximum, replace the new snap ring.
14. INSTALL STARTER COMMUTATOR END FRAME COVER
15. INSTALL STARTER YOKE ASSY
a. Align the starter commutator rubber end frame with the cutout of starter yoke.
b. Install starter yoke assy to starter commutator end frame.
16. INSTALL STARTER COMMUTATOR END FRAME ASSY
a. Align the starter yoke assy with the cutout of motor terminal starter kit.