Matrix 4WD L4-1.8L (1ZZ-FE) (2004)
4
Turn the crankshaft clockwise, and check that the slipper is pushed by the plunger.
HINT: If the plunger does not spring out, press the slipper into the chain tensioner with a screwdriver so that the hook is released from the
knock pin and the plunger springs out.
14. INSTALL V-RIBBED BELT TENSIONER ASSY
a. Install the V-ribbed belt tensioner with the nut and bolt.
Torque: 29 Nm (296 kgf-cm, 21 ft. lbs.) for Nut 69 Nm (704 kgf-cm, 51 ft. lbs.) for Bolt
15. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSY RH
a. Install engine mounting insulator RH with the 4 bolts and the 2 nuts.
Torque: 52 Nm (530 kgf-cm, 38 ft. lbs.)
16. INSTALL CYLINDER HEAD COVER SUB-ASSY
a. Remove any old packing (FIPG) material.
b. Apply seal packing to 2 locations as shown in the illustration.
Seal packing: Part No. 08826-00080 or equivalent
NOTICE:
^
Remove any oil from the contact surface.
^
Install the cylinder head cover within 3 minutes after applying seal packing.
^
Do not put into engine oil 2 hours after installing.