Matrix 4WD L4-1.8L (1ZZ-FE) (2004)
e. Place matchmarks on the outboard joint shaft assy and tripod joint assy.
NOTICE: Do not punch the marks.
f.
Using a brass bar and a hammer, remove the tripod joint assy from the outboard joint shaft assy.
NOTICE: Do not tap the roller.
g. 2WD: Using a snap ring expander, remove the inner LH shaft snap ring.
h. Remove the inboard joint boot LH No. 2 clamp, inboard joint boot and inboard joint boot LH clamp.
23. REMOVE DRIVE SHAFT DAMPER (2WD DRIVE TYPE)
HINT: Perform the procedure only when disassembling the RH side.
a. Using a side cutter, out the drive shaft damper setting clamp, then remove it.
b. Remove the drive shaft damper.
24. REMOVE FRONT AXLE OUTBOARD JOINT BOOT LH No. 2 CLAMP (4WD DRIVE TYPE)
a. One Touch Clamp Type: Using a screwdriver, disclamp the outboard joint boot LH No. 2 clamp.
b. Omega Clamp Type: Using a side cutter, cut the outboard joint LH No. 2 clamp, then remove it.
25. REMOVE FRONT AXLE OUTBOARD JOINT BOOT LH CLAMP (4WD DRIVE TYPE)
a. One Touch Clamp Type: Using a screwdriver, disclamp the outboard joint boot LH clamp.
b. Omega Clamp Type: Using a side cutter, cut the outboard joint LH clamp, then remove it.
26. REMOVE OUTBOARD JOINT BOOT (4WD DRIVE TYPE)
a. Remove the outboard joint boot from the outboard joint shaft assy.