Matrix FWD L4-1.8L (2ZR-FE) (2010)
on each side.
HINT
*
Use the same procedure for the LH side and RH side.
*
The following procedure listed is for the LH side.
1. DRAIN BRAKE FLUID
NOTICE:
If brake fluid leaks onto any painted surface, immediately wash it off.
2. REMOVE FRONT WHEEL
3. REMOVE FRONT FLEXIBLE HOSE
(a) Remove the union bolt and gasket, and separate the front flexible hose from the front disc brake cylinder assembly.
(b) Using a union nut wrench (10 mm), disconnect the brake line while holding the front flexible hose with a wrench.
NOTICE:
*
Do not kink or damage the brake line.
*
Do not allow any foreign matter such as dirt or dust to enter the brake line from the clip or bracket.
(c) Remove the clip.
(d) Remove the bolt and the front flexible hose from the absorber bracket.
Installation
BRAKE (FRONT): FRONT BRAKE FLEXIBLE HOSE: INSTALLATION
NOTICE:
*
Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.
*
If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.
1. INSTALL FRONT FLEXIBLE HOSE
(a) Connect the front flexible hose to the front disc brake cylinder assembly with the union bolt and a new gasket.