Hydraulic Control Assembly - Antilock Brakes - Brake Actuator Service and Repair
10. REMOVE BRAKE ACTUATOR WITH BRACKET (for 2ZR-FE)
(a) Release the lock lever and disconnect the brake actuator connector.
NOTICE:
Be careful not to allow brake fluid to enter the removed connector.
(b) Remove the bolt.
(c) Using a union nut wrench (10 mm) and union nut wrench (12 mm), disconnect the 6 brake lines from the actuator assembly.
(d) Use tags or make a memo to identify the places to reconnect.
HINT
*
*1: To front wheel cylinder RH
*
*2: To front wheel cylinder LH
*
*3: To rear wheel cylinder RH
*
*4: To rear wheel cylinder LH
*
*5: From 1st master cylinder chamber
*
*6: From 2nd master cylinder chamber
(e) Remove the 2 bolts, nut and brake actuator with bracket from the body.
NOTICE:
*
Do not damage the brake lines or wire harness.
*
Do not carry the brake actuator assembly by the connector.
11. REMOVE BRAKE ACTUATOR (for 2AZ-FE)
(a) Remove the 3 bolts and brake actuator from the brake actuator bracket assembly.