Matrix FWD L4-1.8L (2ZR-FE) (2010)
(b) Install the bolt and clamp connect the washer hoses and motor connectors.
Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)
5. INSTALL FRONT BUMPER ASSEMBLY
HINT
Refer to the instructions for Installation of the front bumper assembly See: Body and Frame/Bumper/Front Bumper/Service and
Repair/Removal and Replacement/Installation.
6. INSTALL GENERATOR ASSEMBLY (for 2ZR-FE)
HINT
Refer to the instructions for Installation of the generator assembly See: Starting and Charging/Charging System/Alternator/Service
and Repair/Removal and Replacement/Installation.
7. INSTALL GENERATOR ASSEMBLY (for 2AZ-FE)
HINT
Refer to the instructions for Installation of the generator assembly See: Starting and Charging/Charging System/Alternator/Service
and Repair/Removal and Replacement/Installation.
8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
9. REMOVE CENTER COWL TOP VENTILATOR LOUVER See: Brake Fluid/Service and Repair
10. FILL UP BRAKE FLUID RESERVOIR See: Brake Fluid/Service and Repair
11. BLEED BRAKE MASTER CYLINDER See: Brake Bleeding/Service and Repair
12. BLEED BRAKE LINE See: Brake Fluid/Service and Repair
13. INSPECT BRAKE FLUID LEVEL See: Brake Fluid/Testing and Inspection
14. INSPECT FOR FLUID LEAK
15. INSTALL CENTER COWL TOP VENTILATOR LOUVER See: Brake Fluid/Service and Repair
16. INSPECT ACTUATOR USING TECHSTREAM
HINT
See: Testing and Inspection/Brake Actuator (w/o VSC)
17. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) See: Lighting and Horns/Fog/Driving Lamp/Adjustments
18. INSPECT FOG LIGHT AIMING (w/ Fog Light) See: Lighting and Horns/Fog/Driving Lamp/Adjustments