Matrix FWD L4-1.8L (2ZR-FE) (2010)
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
2. REMOVE FRONT SEAT ASSEMBLY LH
HINT
Refer to the instructions for Removal of the front seat assembly (w/o Seatback Board) See: Body and Frame/Seats/Service and
Repair/Removal and Replacement/Front Seat Assembly (w/o Seatback Board)/Removal.
3. REMOVE FRONT SEAT ASSEMBLY RH (w/o Seatback Board)
HINT
Perform the same procedure for the LH side.
4. REMOVE FRONT SEAT ASSEMBLY RH (w/ Seatback Board)
HINT
Refer to the instructions for Removal of the front seat assembly (w/ Seatback Board) See: Body and Frame/Seats/Service and
Repair/Removal and Replacement/Front Seat Assembly (w/ Seatback Board)/Removal.
5. REMOVE FRONT CONSOLE BOX ASSEMBLY
HINT
Refer to the instructions for Removal of the front console box See: Body and Frame/Interior Moulding / Trim/Console/Service and
Repair/Removal and Replacement/Removal.
6. REMOVE NO. 2 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY See: Parking Brake Lever/Service and Repair/Removal
7. REMOVE NO. 3 BELT ANCHOR REINFORCEMENT SUB-ASSEMBLY See: Parking Brake Lever/Service and Repair/Removal
8. SEPARATE PARKING BRAKE EQUALIZER See: Parking Brake Lever/Service and Repair/Removal
9. REMOVE PARKING BRAKE LEVER ASSEMBLY See: Parking Brake Lever/Service and Repair/Removal
10. REMOVE PARKING BRAKE EQUALIZER See: Parking Brake Lever/Service and Repair/Removal
11. REMOVE PARKING BRAKE CABLE END STOPPER See: Parking Brake Lever/Service and Repair/Removal
12. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY See: Parking Brake Lever/Service and Repair/Removal
13. REMOVE REAR WHEEL
14. REMOVE FRONT EXHAUST PIPE ASSEMBLY (for 2ZR-FE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service
and Repair/Removal
15. REMOVE CENTER EXHAUST PIPE ASSEMBLY (for 2AZ-FE) See: Engine, Cooling and Exhaust/Exhaust System/Exhaust Manifold/Service
and Repair/Removal
16. REMOVE UPPER NO. 1 FRONT FLOOR HEAT INSULATOR
(a) Remove the 3 nuts and upper No. 1 front floor heat insulator.
17. REMOVE UPPER NO. 2 FRONT FLOOR HEAT INSULATOR
(a) Remove the 2 nuts and upper No. 2 front floor heat insulator.