Matrix FWD L4-1.8L (2ZR-FE) (2010)
3. INSTALL VALVE LASH ADJUSTER ASSEMBLY See: Service and Repair/Overhaul/Reassembly
4. INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY See: Service and Repair/Overhaul/Reassembly
5. INSTALL NO. 1 CAMSHAFT BEARING See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation
6. INSTALL NO. 2 CAMSHAFT BEARING See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation
7. INSTALL NO. 2 CAMSHAFT See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation
8. INSTALL CAMSHAFT See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation
9. INSTALL CAMSHAFT BEARING CAP See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation
10. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation
11. INSTALL CAMSHAFT TIMING GEAR ASSEMBLY See: Camshaft, Lifters and Push Rods/Camshaft/Service and Repair/Installation
12. INSTALL CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY See: Camshaft, Lifters and Push Rods/Camshaft/Service and
Repair/Installation
13. INSTALL NO. 1 CHAIN VIBRATION DAMPER
(a) Install the No. 1 chain vibration damper with the 2 bolts.
Torque : 21 Nm (214 kgf-cm, 16 ft-lbf)
14. INSTALL NO. 2 CHAIN VIBRATION DAMPER See: Engine Lubrication/Oil Pump/Service and Repair/Removal and Replacement/Installation
15. INSTALL CHAIN SUB-ASSEMBLY
(a) Check the No. 1 cylinder TDC/compression.
(1) Temporarily tighten the crankshaft pulley bolt.
(2) Turn the crankshaft counterclockwise to position the timing gear key to the top.
(3) Remove the crankshaft pulley bolt.
(4) Check the timing marks on each camshaft timing gear.