Matrix FWD L4-1.8L (2ZR-FE) (2010)
Front Crankshaft Seal: Service and Repair
Installation
2ZR-FE ENGINE MECHANICAL: FRONT CRANKSHAFT OIL SEAL: INSTALLATION
1. INSTALL TIMING CHAIN COVER OIL SEAL
(a) Apply MP grease to the lip of a new oil seal.
NOTICE:
Keep the lip free of foreign matter.
(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST : 09223-22010
NOTICE:
Wipe off extra grease from the crankshaft.
2. INSTALL CRANKSHAFT PULLEY
(a) Align the pulley set key with the key groove of the pulley.
(b) Using SST, hold the pulley in place and tighten the bolt.
SST : 09213-58014
91551-80840
SST : 09330-00021
Torque : 190 Nm (1940 kgf-cm, 140 ft-lbf)
NOTICE:
Check the SST installation positions when installing them to prevent the SST fixing bolts from coming into contact with the timing