Matrix FWD L4-1.8L (2ZR-FE) (2010)
(c) Connect the connector.
3. CONNECT DISCHARGE HOSE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the hose.
(b) Apply sufficient compressor oil to a new O-ring and the fitting surface of the compressor assembly with pulley.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring onto the discharge hose sub-assembly.
(d) Install the discharge hose sub-assembly onto the compressor assembly with pulley with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
4. CONNECT SUCTION HOSE SUB-ASSEMBLY
(a) Remove the attached vinyl tape from the hose.
(b) Apply sufficient compressor oil to a new O-ring and the fitting surface of the compressor assembly with pulley.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring onto the suction hose sub-assembly.
(d) Install the suction hose sub-assembly onto the compressor assembly with pulley with the bolt.
Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)
5. INSTALL V-RIBBED BELT See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Installation
6. ADJUST V-RIBBED BELT See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Installation
7. INSPECT V-RIBBED BELT See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Testing and
Inspection
8. INSTALL ENGINE UNDER COVER RH