Matrix FWD L4-1.8L (2ZR-FE) (2010)
(d) Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
11. REMOVE NO. 1 COOLER THERMISTOR
(a) Remove the No. 1 cooler thermistor from the No. 1 cooler evaporator sub-assembly.
Reassembly
HEATING / AIR CONDITIONING: AIR CONDITIONING UNIT: REASSEMBLY
1. INSTALL NO. 1 COOLER THERMISTOR
(a) Install the No. 1 cooler thermistor as shown in the illustration.
NOTICE:
*
Be sure to insert the thermistor only once because reinserting it will not allow it to be firmly secured.
*
When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).
*
After inserting the thermistor, do not apply excessive force to the wire.
*
Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".
2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
(a) Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces. Install the 2 O-rings to the No. 1 cooler evaporator sub-assembly.
Compressor oil: