Matrix FWD L4-1.8L (2ZR-FE) (2010)
(b) Measure the resistance according to the value(s) in the table below.
HINT
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard resistance:
NG -- REPAIR OR REPLACE CAN MAIN WIRE OR CONNECTOR (CAN NO. 1 JUNCTION CONNECTOR -
COMBINATION METER)
OK -- REPLACE COMBINATION METER See: Instrument Panel, Gauges and Warning Indicators/Instrument Cluster /
Carrier/Service and Repair/Removal and Replacement/Removal
Part One
NETWORKING: CAN COMMUNICATION SYSTEM: Check CAN Bus Line for Short to +B
- Check CAN Bus Line for Short to +B
DESCRIPTION
There may be a short circuit between the CAN bus line and +B when no resistance exists between terminals 6 (CANH) and 16 (BAT) or terminals 14
(CANL) and 16 (BAT) of the DLC3.