Matrix FWD L4-1.8L (2ZR-FE) (2010)
(b) Measure the resistance according to the value(s) in the table below.
HINT
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 1 JUNCTION CONNECTOR -
POWER STEERING ECU)
OK -- REPLACE POWER STEERING ECU See: Relays and Modules/Relays and Modules - Steering and Suspension/Relays and
Modules - Steering/Steering Control Module/Service and Repair/Removal
17. CHECK FOR SHORT TO B+ IN CAN BUS WIRE (CAN NO. 1 JUNCTION CONNECTOR - STEERING ANGLE SENSOR)
(a) Disconnect the steering angle sensor connector.
(b) Measure the resistance according to the value(s) in the table below.