Matrix FWD L4-1.8L (2ZR-FE) (2010)
HINT
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard resistance:
NG -- CHECK FOR SHORT TO GND IN CAN BUS WIRE (CAN NO. 1 JUNCTION CONNECTOR - COMBINATION
METER)
OK -- Continue to next step.
13. CHECK FOR SHORT TO GND IN CAN BUS WIRE (NETWORK GATEWAY ECU BRANCH WIRE)
NOTICE:
For vehicles without the network gateway ECU, go to "CHECK FOR SHORT TO GND IN CAN BUS WIRE (4WD CONTROL ECU
BRANCH WIRE)".
(a) Measure the resistance according to the value(s) in the table below.
HINT
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard resistance: