Matrix FWD L4-1.8L (2ZR-FE) (2010)
Fuel Pressure Regulator: Service and Repair
Removal
2ZR-FE FUEL: FUEL PRESSURE REGULATOR: REMOVAL
1. DISCHARGE FUEL SYSTEM PRESSURE
(a) Discharge fuel system pressure See: Service Precautions.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
3. REMOVE FUEL SUCTION TUBE ASSEMBLY
(a) Remove the fuel suction tube assembly from the fuel tank assembly See: Fuel Pump/Service and Repair/Removal and Replacement/Removal.
4. DRAIN FUEL
5. REMOVE FUEL SENDER GAUGE ASSEMBLY See: Fuel Tank/Fuel Gauge Sender/Service and Repair/Removal
6. REMOVE FUEL PUMP
(a) Disconnect the wire harness connector.
NOTICE:
Do not damage the wire harness.
(b) Disconnect the connector of the fuel pump harness.
(c) Disconnect the fuel pump filter hose.
(d) Remove the E-ring and separate the 2 claws, then remove the fuel pump sub-tank.
NOTICE:
Do not separate the tube indicated in the illustration See: Service Precautions.
(e) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the No. 1 fuel suction support.