Matrix FWD L4-1.8L (2ZR-FE) (2010)
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
5. REMOVE REAR SEAT CUSHION ASSEMBLY See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat
Assembly/Removal
6. REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)
7. REMOVE REAR SEATBACK OUTER HINGE COVER (for LH Side) See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly/Removal
8. REMOVE REAR SEATBACK INNER HINGE COVER (for LH Side) See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly/Removal
9. REMOVE REAR SEATBACK ASSEMBLY LH (for LH Side) See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear
Seat Assembly/Removal
10. REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)
11. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)
12. DISCONNECT REAR SEAT CENTER OUTER BELT ASSEMBLY (for RH Side) See: Seat Belt Systems/Seat Belt/Service and
Repair/Removal and Replacement/Rear Seat Outer Belt Assembly/Removal
13. REMOVE REAR SEATBACK OUTER HINGE COVER (for RH Side) See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly/Removal
14. REMOVE REAR SEATBACK INNER HINGE COVER (for RH Side) See: Body and Frame/Seats/Service and Repair/Removal and
Replacement/Rear Seat Assembly/Removal
15. REMOVE REAR SEATBACK ASSEMBLY RH (for RH Side) See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear
Seat Assembly/Removal
16. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
17. REMOVE REAR SEAT SIDE GARNISH
for LH Side: See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
for RH Side: See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
18. REMOVE REAR AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector from the rear airbag sensor.