Matrix FWD L4-1.8L (2ZR-FE) (2010)
SUPPLEMENTAL RESTRAINT SYSTEMS: SIDE AIRBAG SENSOR: INSTALLATION
1. INSTALL SIDE AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Aligning the pin of the side airbag sensor to the body hole, install the side airbag sensor with the bolt.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with
a new one.
*
When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched
between other parts.
*
Make sure that the pin is securely inserted into the body hole.
*
Tighten the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.
(d) Connect the connector to the side airbag sensor.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(e) Check that there is no looseness in the installation parts of the side airbag sensor.
2. INSTALL LOWER CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
3. CONNECT FRONT SEAT OUTER BELT ASSEMBLY (for Driver Side) See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
4. INSTALL LAP BELT OUTER ANCHOR COVER (for Driver Side) See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
5. CONNECT FRONT SEAT OUTER BELT ASSEMBLY (for Front Passenger Side) See: Restraint Systems/Seat Belt Systems/Seat Belt/Service
and Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
6. INSTALL LAP BELT OUTER ANCHOR COVER (for Front Passenger Side) See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Removal and Replacement/Front Seat Outer Belt Assembly/Installation
7. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
for LH Side: See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
for RH Side: See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
8. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
9. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
for LH Side: See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation