Matrix FWD L4-1.8L (2ZR-FE) (2010)
SST : 09960-20010
09961-02060
NOTICE:
Make sure that the upper ends of the tie rod end and SST are aligned.
(c) Using SST, separate the tie rod end from the steering knuckle.
SST : 09960-20010
09961-02010
CAUTION:
Apply grease to the bolt threads and the tip of SST.
NOTICE:
*
Be sure to tighten the string firmly to secure SST to the steering knuckle to prevent SST from falling off.
*
Install SST with the center nut so that A and B are parallel. Otherwise, the dust cover may be damaged.
*
Be sure to place the wrench on the part indicated in the illustration.
*
Do not damage the front disc brake dust cover.
*
Do not damage the ball joint dust cover.
*
Do not damage the steering knuckle.
10. SEPARATE TIE ROD END SUB-ASSEMBLY RH
HINT
Use the same procedure for the LH side.
11. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH See: Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal
and Replacement/Front Shock Absorber/Removal
12. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
HINT
Use the same procedure for the LH side.
13. SEPARATE FRONT LOWER SUSPENSION ARM LH See: Suspension/Ball Joint/Service and Repair/Removal
14. SEPARATE FRONT LOWER SUSPENSION ARM RH
HINT