Matrix FWD L4-1.8L (2ZR-FE) (2010)
(a) Align the round hole in the No. 1 steering column hole cover sub-assembly with the protrusion of the steering link assembly to install the
cover.
6. INSTALL FRONT SUSPENSION CROSSMEMBER See: Suspension/Cross-Member/Front Cross-Member/Service and Repair/Installation
7. CONNECT FRONT LOWER SUSPENSION ARM LH See: Suspension/Ball Joint/Service and Repair/Installation
8. CONNECT FRONT LOWER SUSPENSION ARM RH
HINT
Use the same procedure for the LH side.
9. INSTALL FRONT STABILIZER LINK ASSEMBLY LH See: Suspension/Suspension Strut / Shock Absorber/Service and Repair/Removal and
Replacement/Front Shock Absorber/Installation
10. INSTALL FRONT STABILIZER LINK ASSEMBLY RH
HINT
Use the same procedure for the LH side.
11. CONNECT TIE ROD END SUB-ASSEMBLY LH
(a) Connect the tie rod end sub-assembly LH to the steering knuckle with the nut.
Torque : 49 Nm (500 kgf-cm, 36 ft-lbf)
NOTICE:
Further tighten the nut up to 60° if the holes for the cotter pin are not aligned.
(b) Install a new cotter pin.
12. CONNECT TIE ROD END SUB-ASSEMBLY RH
HINT
Use the same procedure for the LH side.
13. CONNECT NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY