Matrix FWD L4-1.8L (2ZR-FE) (2010)
(b) Disengage the 6 clamps and separate the wire harness and hose.
(c) Support the rear suspension member using a jack and wooden block.
(d) Remove the 2 bolts and 2 nuts from the rear suspension member.
(e) Lower the rear suspension member.
64. REMOVE UPPER CONTROL ARM ASSEMBLY LH See: Control Arm/Service and Repair/Rear Upper Arm/Removal
65. REMOVE UPPER CONTROL ARM ASSEMBLY RH
HINT
Perform the same procedure for the LH side.
66. REMOVE REAR NO. 1 STABILIZER BAR BRACKET See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar (for Double Wishbone Type
Suspension)/Removal
67. REMOVE REAR STABILIZER BUSHING See: Stabilizer Bar/Service and Repair/Rear Stabilizer Bar (for Double Wishbone Type
Suspension)/Removal
68. REMOVE REAR STABILIZER BAR
69. REMOVE NO. 6 EXHAUST PIPE SUPPORT BRACKET (for 4WD)
(a) Remove the 2 bolts and No. 6 exhaust pipe support bracket.