Matrix FWD L4-1.8L (2ZR-FE) (2010)
18. REMOVE NO. 1 PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for 4WD) See: Brakes and Traction Control/Parking Brake
System/Service and Repair/Disassembly
19. REMOVE NO. 2 PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for 4WD) See: Brakes and Traction Control/Parking Brake
System/Service and Repair/Disassembly
20. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY (for 4WD) See: Wheel Hub/Service and Repair/Rear Axle Hub (for Double
Wishbone Type Suspension)/Removal
21. SEPARATE REAR SPEED SENSOR (for 4WD) See: Wheel Hub/Service and Repair/Rear Axle Hub (for Double Wishbone Type
Suspension)/Removal
22. SEPARATE REAR STABILIZER LINK ASSEMBLY
(a) Remove the nut, separate the rear stabilizer link assembly.
HINT
If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.
23. SEPARATE UPPER CONTROL ARM ASSEMBLY
(a) Remove the nut and bolt, separate the upper control arm assembly.
HINT
Keep the nut fixed while loosening and removing the bolt.
(b) Using a brass bar and a hammer, separate the upper control arm assembly from the rear axle carrier sub assembly.
NOTICE:
Be careful not to damage the speed sensor wire.
24. SEPARATE REAR NO. 1 SUSPENSION ARM ASSEMBLY
(a) Place matchmarks on the camber adjust cam and the rear No. 1 suspension arm assembly.