Matrix FWD L4-1.8L (2ZR-FE) (2010)
7. INSTALL REAR STABILIZER LINK ASSEMBLY
(a) Install the rear stabilizer link assembly with the nut.
Torque : 44 Nm (449 kgf-cm, 32 ft-lbf)
HINT
If the ball joint turns together with the nut, use a hexagon wrench (5 mm) to hold the stud.
8. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for 2WD) See: Wheel Hub/Service and Repair/Rear Axle Hub (for Double
Wishbone Type Suspension)/Installation
9. INSTALL REAR SPEED SENSOR WIRE (for 2WD)
(a) Install the rear speed sensor wire with the bolt.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
10. CONNECT REAR SPEED SENSOR WIRE (for 2WD) See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Wheel
Speed Sensor/Service and Repair/Rear Speed Sensor/Installation
11. INSTALL REAR SPEED SENSOR (for 4WD) See: Wheel Hub/Service and Repair/Rear Axle Hub (for Double Wishbone Type
Suspension)/Installation
12. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY (for 4WD) See: Wheel Hub/Service and Repair/Rear Axle Hub (for Double
Wishbone Type Suspension)/Installation
13. APPLY HIGH TEMPERATURE GREASE (for 4WD) See: Brakes and Traction Control/Parking Brake System/Service and Repair/Reassembly
14. INSTALL NO. 1 PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for 4WD) See: Brakes and Traction Control/Parking Brake
System/Service and Repair/Reassembly