Matrix FWD L4-1.8L (2ZR-FE) (2010)
Tire Pressure Monitor Receiver / Transponder: Service and Repair
Installation
TIRE PRESSURE MONITORING: TIRE PRESSURE WARNING RECEIVER: INSTALLATION
1. INSTALL TIRE PRESSURE WARNING ANTENNA AND RECEIVER
(a) Connect the connector.
(b) Install the tire pressure warning antenna and receiver with the bolt.
Torque : 7.5 Nm (76 kgf-cm, 66 in-lbf)
HINT
Engage the 2 tabs into the holes as shown in the illustration to install the tire pressure warning antenna and receiver.
2. INSTALL ROOF SIDE INNER GARNISH LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
3. INSTALL QUARTER PILLAR GARNISH LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
4. INSTALL SIDE DECK TRIM PANEL ASSEMBLY LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
5. INSTALL REAR COMBINATION LIGHT SERVICE COVER LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
6. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Installation
7. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service
and Repair/Installation
8. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH See: Restraint Systems/Seat Belt Systems/Seat Belt/Service and
Repair/Removal and Replacement/Rear Seat Outer Belt Assembly/Installation
9. INSTALL REAR SEAT SIDE GARNISH LH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
10. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY (for LH Side) See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation