Matrix FWD L4-1.8L (2ZR-FE) (2010)
/Page-1267025.png)
(c) If the tightening torque of the rear drive pinion nut exceeds 245 N*m (2500 kgf*cm, 181 ft.*lbf) but the preload is still insufficient, loosen the
rear drive pinion nut. Then check if the rear drive pinion nut and differential drive pinion screw threads are damaged.
(d) If there is no defect, replace the rear drive differential drive pinion bearing spacer, apply hypoid gear oil LSD to its threads and repeat the
procedure above.
23. INSTALL REAR DIFFERENTIAL CASE SUB-ASSEMBLY
(a) Install the rear differential case to the rear differential carrier.
24. INSTALL DIFFERENTIAL SIDE BEARING RETAINER
(a) Install the differential side bearing retainer to the rear differential carrier with the 10 bolts.
Torque : 42 Nm (430 kgf-cm, 31 ft-lbf)
25. INSPECT DIFFERENTIAL RING GEAR BACKLASH
(a) Insert a dial indicator through the rear differential carrier cover plug hole, and set it perpendicular to a ring gear tooth tip.
(b) Using SST, hold the drive pinion in place.
SST : 09556-16011
(c) Using SST, rotate the rear differential case forward and backward, and measure the backlash.
SST : 09564-32011
