Matrix FWD L4-1.8L (2ZR-FE) (2010)
Torque : 137 Nm (1400 kgf-cm, 101 ft-lbf)
3. INSTALL NO. 6 EXHAUST PIPE SUPPORT BRACKET See: Body and Frame/Frame/Cross-Member/Rear Cross-Member/Service and
Repair/Installation
4. INSTALL REAR SUSPENSION MEMBER
HINT
Refer to the instructions for installation of the rear suspension member See: Body and Frame/Frame/Cross-Member/Rear
Cross-Member/Service and Repair/Installation.
5. ADD DIFFERENTIAL OIL See: Fluid - Differential/Service and Repair
6. INSPECT AND ADJUST DIFFERENTIAL OIL See: Fluid - Differential/Service and Repair
7. INSPECT FOR EXHAUST GAS LEAK
8. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
See: Maintenance/Alignment/Service and Repair/Rear Wheel Alignment (for Double Wishbone Type Suspension)
9. CHECK FOR SPEED SENSOR SIGNAL
w/o VSC See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/ABS (Antilock Brake System)/Test Mode Procedure
w/ VSC See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection and Diagnostic
Overview/Vehicle Stability Control System/Test Mode Procedure