Matrix FWD L4-1.8L (2ZR-FE) (2010)
SST : 09240-00020
Standard clearance:
1.2 to 4.0 mm (0.0473 to 0.157 in.)
NOTICE:
If the clearance is outside the specified range, retighten SST.
4. INSTALL FRONT AXLE OUTBOARD JOINT BOOT CLAMP
(a) Place SST onto the boot clamp, press it against the boot and slightly tighten SST.
SST : 09521-24010
(b) Tighten SST so that the clearance comes within the specified range.
NOTICE:
Do not overtighten SST.
(c) Remove SST.
(d) Using SST, measure the clearance of the boot clamp as shown in the illustration.
SST : 09240-00020
Standard clearance:
1.2 to 4.0 mm (0.0473 to 0.157 in.)
NOTICE:
If the clearance is outside the specified range, retighten SST.
5. INSTALL FRONT DRIVE SHAFT DAMPER RH
(a) Install the drive shaft damper onto the front axle outboard shaft assembly as shown in the illustration.