Matrix FWD L4-2.4L (2AZ-FE) (2009)
(e) Remove the No. 1 sensor clamp from the shock absorber.
(f) Remove the clamp.
(g) Remove the bolt and front speed sensor.
NOTICE:
-
Prevent foreign matter from attaching to the sensor tip.
-
Clean the installation hole and the contact surface for the speed sensor every time it is removed.
Installation
BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS: FRONT SPEED SENSOR: INSTALLATION
INSTALLATION
HINT:
-
Use the same procedure for the RH side and LH side.
-
The procedure listed below is for the LH side.
-
If the sensor rotor needs to be replaced, replace it together with the front drive shaft assembly.
1. INSTALL FRONT SPEED SENSOR