Matrix FWD L4-2.4L (2AZ-FE) (2009)
Brake Light Switch: Service and Repair
Installation
LIGHTING (EXT): STOP LIGHT SWITCH: INSTALLATION
INSTALLATION
1. INSTALL STOP LIGHT SWITCH ASSEMBLY
(a) Insert the stop light switch assembly until the rod hits the cushion.
NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not depressed.
(b) Make a quarter turn clockwise to install the stop light switch assembly.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)
NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not depressed.
(c) Connect the connector.
(d) Check the protrusion of the rod.
Protrusion of the rod:
1.5 to 2.5 mm (0.0591 to 0.0984 in.)
If the protrusion is not within the specified range, adjust it.
NOTE: Do not depress the brake pedal.