Matrix FWD L4-2.4L (2AZ-FE) (2009)
4. REMOVE PARKING BRAKE LEVER PROTECTOR (for Torsion Beam Type Suspension) See: Brakes and Traction Control/Parking Brake
System/Parking Brake Lever/Service and Repair/Removal
5. DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY (for Torsion Beam Type Suspension) See: Brakes and Traction Control/Disc
Brake System/Service and Repair/Removal and Replacement/Rear Brake (for Torsion Beam Type Suspension)/Removal
6. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY (for Torsion Beam Type Suspension)
(a) Remove the 2 bolts, and separate the rear disc brake caliper assembly.
NOTE: Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.
7. REMOVE REAR DISC (for Torsion Beam Type Suspension) See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal
and Replacement/Rear Brake (for Torsion Beam Type Suspension)/Removal
8. REMOVE REAR AXLE HUB BOLT (for Torsion Beam Type Suspension)
(a) Temporarily install the 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.
(b) Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.
SST: 09628-10011
9. INSTALL REAR AXLE HUB BOLT (for Torsion Beam Type Suspension)
(a) Install a washer and nut to a new rear axle hub bolt as shown in the illustration.
(b) Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.
10. INSTALL REAR DISC (for Torsion Beam Type Suspension) See: Brakes and Traction Control/Disc Brake System/Service and Repair/Removal
and Replacement/Rear Brake (for Torsion Beam Type Suspension)/Installation
11. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY (for Torsion Beam Type Suspension)