Matrix FWD L4-2.4L (2AZ-FE) (2009)
3. REMOVE REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
4. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
5. REMOVE REAR SEAT CUSHION ASSEMBLY See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly/Removal
6. REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)
7. REMOVE REAR SEATBACK OUTER HINGE COVER (for LH Side) See: Body and Frame/Seats/Service and Repair/Rear Seat
Assembly/Removal
8. REMOVE REAR SEATBACK INNER HINGE COVER (for LH Side) See: Body and Frame/Seats/Service and Repair/Rear Seat
Assembly/Removal
9. REMOVE REAR SEATBACK ASSEMBLY LH (for LH Side) See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly/Removal
10. REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)
11. REMOVE REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)
12. DISCONNECT REAR SEAT CENTER OUTER BELT ASSEMBLY (for RH Side) See: Seat Belt Systems/Seat Belt/Service and Repair/Rear
Seat Outer Belt Assembly/Removal
13. REMOVE REAR SEATBACK OUTER HINGE COVER (for RH Side) See: Body and Frame/Seats/Service and Repair/Rear Seat
Assembly/Removal
14. REMOVE REAR SEATBACK INNER HINGE COVER (for RH Side) See: Body and Frame/Seats/Service and Repair/Rear Seat
Assembly/Removal
15. REMOVE REAR SEATBACK ASSEMBLY RH (for RH Side) See: Body and Frame/Seats/Service and Repair/Rear Seat Assembly/Removal
16. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Removal
17. REMOVE REAR SEAT SIDE GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Removal
18. REMOVE REAR AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Disconnect the connector from the rear airbag sensor.
NOTE: When disconnecting the airbag connector, take care not to damage the airbag wire harness.
(d) Remove the nut and disengage the pin, and remove the rear airbag sensor.
NOTE: Loosen the nut while holding the rear airbag sensor because the rear airbag sensor pin (stopper) is easily damaged.
Installation
SUPPLEMENTAL RESTRAINT SYSTEMS: REAR AIRBAG SENSOR: INSTALLATION
INSTALLATION
1. INSTALL REAR AIRBAG SENSOR
(a) Check that the ignition switch is off.
(b) Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
(c) Aligning the pin of the rear airbag sensor to the body hole, install the rear airbag sensor with the nut.