Matrix FWD L4-2.4L (2AZ-FE) (2009)
Crankshaft Position Sensor: Service and Repair
Removal
2AZ-FE ENGINE CONTROL: CRANKSHAFT POSITION SENSOR: REMOVAL
REMOVAL
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
2. REMOVE ENGINE UNDER COVER RH
3. REMOVE V-RIBBED BELT See: Engine, Cooling and Exhaust/Engine/Drive Belts, Mounts, Brackets and Accessories/Drive Belt/Service and
Repair/Removal
4. REMOVE GENERATOR ASSEMBLY See: Starting and Charging/Charging System/Alternator/Service and Repair/Removal and
Replacement/Removal
5. REMOVE CRANKSHAFT POSITION SENSOR
(a) Disconnect the crankshaft position sensor connector.
(b) Separate the crankshaft position sensor connector clamp and wire harness.
(c) Remove the bolt and crankshaft position sensor.