Matrix FWD L4-2.4L (2AZ-FE) (2009)
Clutch Slave Cylinder: Overhaul
Disassembly
CLUTCH: CLUTCH RELEASE CYLINDER (for E351): DISASSEMBLY
DISASSEMBLY
1. REMOVE RELEASE CYLINDER BLEEDER PLUG
(a) Remove the bleeder plug from the cylinder body.
(b) Remove the bleeder plug cap from the bleeder plug.
2. REMOVE CLUTCH RELEASE CYLINDER KIT
(a) Remove the boot from the cylinder body.
(b) Remove the push rod from the cylinder body.
(c) Remove the piston and spring from the cylinder body.
NOTE: Do not damage the inside of the cylinder body.
Reassembly
CLUTCH: CLUTCH RELEASE CYLINDER (for E351): REASSEMBLY
REASSEMBLY
1. INSTALL CLUTCH RELEASE CYLINDER KIT
(a) Coat a new piston with lithium soap base glycol grease as shown in the illustration.
(b) Install the piston and a new spring to the cylinder body.
NOTE: Do not damage the inside of the cylinder body.
HINT: Install the smaller end of the spring to the piston.
(c) Install a new boot to the push rod.
(d) Install the push rod to the cylinder body.
2. INSTALL RELEASE CYLINDER BLEEDER PLUG
(a) Install the bleeder plug to the cylinder body.
Torque: 8.4 Nm (86 kgf-cm, 74 in-lbf)
(b) Install the bleeder plug cap to the bleeder plug.