Matrix FWD L4-2.4L (2AZ-FE) (2009)
(c) Using a screwdriver, pull out the stopper of the transmission control cable.
NOTE: Do not remove the stopper. If it is removed, reinstall it to its original position.
(d) Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from
the shift lever retainer.
NOTE: Do not rotate the nut excessively as it will come off the internal spring and the transmission control cable will not be reusable.
(e) Remove the 2 clips and disconnect the 2 transmission control cables from the control cable bracket*1.
(f) Remove the 2 clips and disconnect the 2 transmission control cables from the transaxle*2.
(g) Remove the nut and transmission control cable assembly.