Matrix FWD L4-2.4L (2AZ-FE) (2009)
(b) Install the outer part of the transmission control cable to the shift lever retainer, check that the position of the spring is the same as A shown in
the illustration, and push in the stopper.
HINT: If the stopper cannot be pushed in, slightly rotate the nut clockwise and then push in the stopper.
(c) Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the
bottom of the lock piece toward each other and upward to pull out the lock piece.
(d) Install the control shift cable to the shift lever assembly.
(e) Install the control select cable to the shift lever assembly.
NOTICE:
-
Make sure that the lock piece is protruding from the adjuster case.
-
Make sure to adjust the length at the neutral shift position.