Matrix XR 2WD L4-1.8L (1ZZ-FE) (2003)
![background image](/toyota/matrix_xr_2wd/l4-1.8l_(1zz-fe)/Page-102002.png)
b. Place the speed sensor on the axle hub so that the connector makes the lowest position under the on-vehicle condition.
c. Using SST and press, install the new speed sensor to the axle hub.
SST 09214-76011
9. INSTALL REAR AXLE HUB & BEARING ASSY LH
10. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the skid control sensor wire connector to the skid control sensor.
11. INSTALL REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
12. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
13. INSTALL REAR DISC BRAKE CALIPER ASSY LH (DISC REAR BRAKE TYPE)
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 7fi ft. lbs.)
15. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
16. CHECK ABS SPEED SENSOR SIGNAL