Matrix XRS 2WD L4-1.8L (2ZZ-GE) (2003)
/Page-681016.png)
49. INSTALL FRONT SUSPENSION ARM SUB-ASSY LOWER No. 1 LH
a. Install the lower ball joint to the front suspension arm sub-assy lower No. 1 LH with the bolt and 2 nuts.
Torque: 89 Nm (908 kgf-cm, 66 ft. lbs.)
50. INSTALL TIE ROD END SUB-ASSY LH
a. Install the tie rod end sub-assy LH to the steering knuckle with the nut.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
b. Install a new cotter pin.
NOTICE: If the holes for the cotter pin are not aligned, tighten the nut further to 60°.
51. INSTALL SPEED SENSOR FRONT LH
a. Install the speed sensor front LH and flexible hose to shock absorber assy front LH with the bolt.
Torque: 29 Nm (296 kgf-cm, 21 ft. lbs.)
b. Install the speed sensor front LH to the steering knuckle with the bolt.
Torque: 8.0 Nm (82 kgf-cm, 71 ft. lbs.)
NOTICE:
^
Be careful not to damage the speed sensor.
^
Keep the speed sensor clean.
^
Do not twist the sensor wire when installing the sensor.
52. INSTALL FRONT STABILIZER LINK ASSY LH
a. Install the front stabilizer link assy LH with the nut.
Torque: 74 Nm (755 kgf-cm, 55 ft. lbs.)