MR2 L4-122 1998cc 2.0L DOHC Turbo (3S-GTE) (1991)
15. Remove hose clamp and VTV clamp off air by-pass valve.
16. Remove cylinder head cover.
17. Remove spark plugs.
18. Remove No.2 timing belt cover.
Remove the five screws, timing belt cover and gasket.
19. Set cylinder to TDC/compression.
(a) Turn the crankshaft pulley and align its groove with timing mark "0" of the No.1 timing belt cover.
NOTICE:Always turn the crankshaft clockwise.
(b) Check that the timing marks of the camshaft timing pulleys are aligned with the timing marks of the No.3 timing belt cover. If not, turn the
crankshaft one revolution (360°).
20. Remove timing belt from camshaft timing pulleys.
HINT:
-
(Re-using timing belt)
Place matchmarks on the timing belt and camshaft timing pulleys and place a matchmark on the timing belt to match the end of the No.1 timing