MR2 L4-132 2164cc 2.2L DOHC (5S-FE) (1993)
17. REMOVE CAMSHAFT TIMING PULLEY
Using SST, remove the bolt and timing pulley.
SST 09249-63010,09960-10010 (09962-01000, 09963-01000)
18. REMOVE CRANKSHAFT PULLEY
(a) Using SST, remove the pulley bolt.
SST 09213-54015 (09214-00030), 09330-00021
HINT (When re-using timing belt): After loosening the crankshaft pulley bolt, check that the timing belt matchmarks aligns with the end of
the No.1 timing belt cover when the crankshaft pulley groove is aligned with the timing mark "0" of the No.1 timing belt cover. If the
matchmarks do not align, align as follows:
When matchmarks are out of alignment clockwise:
-
Align the matchmarks by pulling the timing belt up on the water pump pulley side while turning the crankshaft pulley counterclockwise.