MR2 L4-132 2164cc 2.2L DOHC (5S-FE) (1993)
Fig. 7 Intake Valve Shim Size Chart
Fig. 8 Exhaust Valve Shim Size Chart
11.
Using a micrometer measure thickness of removed shim, record this dimension.
12.
Determine difference between desired and actual valve clearance measurement, add difference to dimension of measured shim. Refer to shim
charts Fig. 7 through 8 to select a replacement.
13.
Install new shim in lifter, then remove lifter tools. Repeat steps 9 through 12 for any other valves found out of adjustment.
14.
Rotate crankshaft pulley two full turns, recheck valves as outlined in steps 7 through 9.
15.
Turn crankshaft pulley 360° (one complete revolution) and align timing marks as outlined previously and check the following valves:
a. No. 2 exhaust valves.
b. No. 3 intake valves.
c. No. 4 intake and exhaust valves. Repeat steps 10 through 14, if necessary.
16.
Reinstall removed parts, bleed cooling system. If audio system was disabled, activate as outlined under Technician Safety Information.