MR2 L4-132 2164cc 2.2L DOHC (5S-FE) (1993)
/Page-634002.png)
9.
Remove valve body, then the governor apply gasket.
10.
On A131L models, remove governor oil strainer.
INSTALLATION
1.
On A131L models, install governor oil strainer.
2.
Install governor apply gasket.
3.
On all models except A131L, connect manual valve connecting rod.
4.
Hold valve body in place, then manually retain cam in downward position and slip cable end into slot.
5.
Position valve body in installation position, then insert and finger tighten attaching bolts. Tighten to specifications. Attaching bolt lengths (mm)
are indicated in, Figs. 5 through 8.
6.
On models except A131L, connect solenoid connector.
7.
On A131L models, align manual valve with pin on manual valve lever, then install manual valve body.
8.
Insert and finger tighten attaching bolts, then tighten to specifications.
9.
Install detent spring, then insert and finger tighten attaching bolt. Tighten attaching bolts to specifications.
10.
Ensure manual lever is in contact with center of roller at tip of detent spring, then install oil tubes.
11.
On models except A131L, install and tighten tube clamp attaching bolt to specifications.
12.
On A131L models, install apply tube bracket, tighten to specifications.
13.
Install oil strainer.
14.
Insert magnet into pan, then install oil pan with new gasket.
15.
Insert oil pan attaching bolts, then tighten to specifications.
16.
Install drain plug with new gasket, then tighten to specifications.
17.
Install engine undercover.
18.
Fill transaxle to specifications, then ensure proper fluid level.
