MR2 L4-1587cc 1.6L DOHC SC (4A-GZE) (1988)
3. REMOVE SELECT INNER LEVER
a. Using a pin punch and hammer, drive out the slotted spring pin.
b. Remove the select inner lever, No.1 compression spring and No.1 select spring seat.
4. REMOVE SNAP RING
Using two screwdrivers and a hammer, remove the snap ring.
Assembly
1. COAT SHAFT WITH MP GREASE, AS SHOWN
2. INSTALL SNAP RING
Using a plastic hammer, install the snap ring.
3. INSTALL SELECT INNER LEVER