MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
/Page-1154002.png)
HINT: Tape the screwdriver tip before use.
b. Employ the same manner described above to the other side.
7. REMOVE REAR ROOF SIDE FINISH MOULDINGS
a. Remove the 4 screws and rear roof side finish moulding.
b. Employ the same manner described above to the other side.
CAUTION: Before removing the moulding, mark the positioning with a colored pencil on the installation holes.
8. REMOVE TARPAULIN COVER
a. Close the tarpaulin lightly and cut out the tie lap band.
b. Remove the clip.
c. Pull up the spring cover and remove the spring B.