MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
g. Install the clamp with the bolt.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
h. Connect the front speed sensor connector.
i.
Install the fender liner.
j.
Connect sensor connector to the speed sensor.
k. Check the speed sensor signal.
3. RH SIDE: REPLACE FRONT SPEED SENSOR SUB-WIRE
a. Disconnect the sensor connector from the speed sensor.
b. Remove the fender liner.