MR2 Spyder L4-1.8L (1ZZ-FE) (2001)
3. DISCONNECT FLEXIBLE HOSE FROM CALIPER
Remove the union bolt and gasket from the caliper, then disconnect the flexible hose.
Torque: 30 Nm (310 kgf-cm, 22 ft. lbs.)
HINT:
^
At the time of installation, insert the flexible hose lock securely in the lock hole in the caliper.
^
Use a container to catch the brake fluid as it drains out.
4. REMOVE CALIPER
Remove the installation bolt and caliper from the torque plate.
Torque: 20 Nm (204 kgf-cm, 15 ft. lbs.)
5. REMOVE 2 PADS WITH 4 ANTI-SQUEAL SHIMS
6. REMOVE 4 PAD SUPPORT PLATES
INSTALLATION
Installation is in the reverse order of removal.
HINT:
^
After installation, fill the brake reservoir with brake fluid and bleed the brake system.
^
Check for leaks.
Disassembly and Assembly